Issues to be aware of when using can sealers

Issues to note when using a sealer:
1. There are 12 stations (i.e. 12 equal parts) per turn of the sealed rotating device. The diverter parameters, deceleration parameters and related parameters listed in the list of purchased parts are for reference only, as these need to be determined based on the output per minute required by the user.
Sealing machine 2. There is always an amount of butter (molybdenum disulfide grease) stored in the gearbox.
3. Refuel the USS “Dan Mtep” U.S.-class battleship once.
Sealing machine 4. Oil seals should be installed on both sides of each radial bearing (driven by part 6). Power cord factory
Sealing machine 5. The round pin φ8 with part number 24# should be pressed in and then fixed using a thin spring steel sheet z (after adjustment by a surface grinder, its thickness d = 0.5 ± 0.02 and its clearance d = 0.03 - 0.05), with frequent addition of lubricating oil to achieve lubrication.
6. Before installing needle roller bearings and cylindrical roller bearings, apply lubricant to each roller ring.
Sealing machine 7. Part No. 41# Used flat bearings should also be lubricated.
8. The shape and construction of the sealing rollers and rollers are for reference only.
Sealing machine 9. In South Korea, the turntable material is made of hard plastic; in the range, phenolic resin or aluminum alloy plates are used. The first requirement is that it is non-magnetic, followed by easy processing and maintaining precision, and thirdly, it must not deform. Please choose wisely.
10. For bottles of different diameters, turntables and indents with different positioning arcs are used. Freer

11. Automation and coordination of electrical equipment, segmentation, indexing, and production of cylinders are all controlled by programmable logic controllers (PLCs) and designed by electrical engineers.
12. At the feed end, an additional conveyor belt without motor is used for emptying the tanks, which is approximately 2 mm long.
13. The production of doormen and doors can be carried out according to the basic model and with reference to the video.
14. The turntable end point electronic photosensitive element assembly with part number 112# can be installed on the workbench below the turntable to install the induction photocell at the idle turntable, or you can refer to this general drawing or video for installation. The specific installation method is determined by the electrical engineer.